Toyota RAV 4 Roof Rack Kits and Accessories

This 1358mm/53.5" long full-size Slimline II cargo roof rack kit contains the Slimline II Tray, Wind Deflector and 2 Foot Rails to mount the Slimline II Tray to your Toyota Rav4 2019+. Easily installs using the existing mounting points. No drilling required. All Front Runner Rack Kits contain installation instructions as well as all the components needed to mount the Slimline II Tray to your vehicle.  All Front Runner Racks are backed by a Limited Lifetime Warranty*Note: The factory glass sun roof is only operational with vent mode and can not be fully retracted to open with this Rack Kit fitted. This Rack Kit is not suitable for Rav4 Adventure, TRD or LE models.   KRTR004T - Toyota Rav4 (2019-Curr) SLII Roof Rack Kit Consisting of: 1 x FATR001 - Toyota Rav4 (2019-Current) Foot Rails - by Front Runner1 x RRSTD07 - Slimline II Tray - 1255mm(W) X 1358mm(L) - by Front Runner Material used: Black epoxy powder-coated T6 aluminiumHigh strength steel Approximate Installed Weight 24.9kg (54.8lbs) The t-slots on the tops and bottoms of the rack tray slats and edge profiles accommodate standard 8mm bolts. To determine the approximate height from your vehicle’s roof to the top of your Slimline II Roof Rack, add the height of the Slimline II Tray (50mm/ 2") to the height of the Foot or Grab-on Foot listed above.If your Slimline II Roof Rack kit uses Legs, add the height of the Slimline II Tray (50mm/ 2") to the height of the Legs to determine the height of the rack from your vehicle’s rain gutters.If your Slimline II Roof Rack kit uses Foot Rails, add the height of the Slimline II Tray (50mm/ 2") to the height of the Foot Rails to determine the height of the rack from the crown (highest point) of the vehicles roof.Shipping Dimensions: Width 450mm (18")Length 1610mm (63")Height 260mm (10") Shipping Weight: Weight 24.9kg (54.8lbs)

This low-profile flat deck Slimsport rack has a load-carrying area of 1676mm (66") x 1175mm (46.3"). The sleek side rails have integrated mounting feet. The mounting feet also have additional brace brackets for added strength. The high-strength aluminum slats have T-slots suitable for all Front Runner top mount accessories. Effortlessly access your Slimsport cargo with the Handle/Light Slimsport Rack Bracket. Easily add on the Slimsport/Slimpro Van Side Mount Accessory Bracket / Small by Front Runner for most Front Runner side mount accessories (sold separately). Included in the Toyota Rav4 (2019-Current) Slimsport is a 40" cutout to allow the use of the 40" LED Slim Light Bar VX1000-CB SM / 12V/24V / Single Mount (sold separately), and allows full operation of the moon roof. Fitment guide and all mounting hardware included. 6"/T30 Torx Allen Key for Slimsport Rack is required for installation. Note: Drilling required for installation. Note: Under Rack Tables and some side mount accessories such as Hi-Lift Jack Bracket and Recovery Device & Gear Holding Side Brackets are not compatible with the Slimsport rack kit range. All Front Runner Racks are backed by a Limited Lifetime Warranty* Please Note: Additional drilling is required for the RAV4 LE models. Features KSTR002T - Toyota Rav4 (2019-Current) Slimsport Roof Rack Kit / Lightbar ready - by Front Runner Consisting of: 1x KSTR001 - Toyota Rav4 (2019-Current) Slimsport Roof Rack 1x RRAC220 - Toyota Rav4 Slimsport Rack 40" Light Bar Wind Fairing 1x RRAC971 - Protection Strip Installation Hardware Fitting Instructions Material used: Black epoxy powder - coated T6 aluminium High strength steel Assembled Rack Dimensions: 1676mm (66") L x 1175mm (46.3") W x 135mm (5.3") H Approximate Installed Weight: 33.94kg (74.82lbs) The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts. To determine the approximate height from your vehicles roof to the top of your Slimsport Rack add 60mm-70mm (2.4"-2.8") to the highest point of your roof. Shipping Dimensions: Width: 330mm (13") Length: 1705mm (67") Height: 220mm (9") Shipping Weight: Weight: 34kg (75lbs)

Introducing the VSS System for the Toyota RAV4 (2019 – 2026), the World’s First Vehicle Specific Bonnet-Mounted Solar Panel System. Key Features:  86W of clean solar energy to keep your battery topped up when the engine isn't running. Rugged “Marine-Grade” construction to withstand extreme environmental conditions. Perfect for overlanding, camping, and the jobsite. Keep your drinks cold and equipment charged without killing your battery. Solar Made Simple: An optional solar controller makes for everything you need for a clean and simple install. 3-year warranty. Approximate Installation Time - 1.5 Hours  Installation Difficulty - EasyBenefits– Keep your vehicles battery topped up at all times: Perfect for the overlander or camper who wants to power devices without worrying about draining their battery. Perfect on the jobsite for work lights and charging cordless tools. – Extend the life of your battery: The VSS System will give you longer overall battery life by tending it constantly during periods of sun exposure. – Emergency engine starting device: If you ever manage to completely drain your battery the VSS will start the vehicle up again in as little as 30 minutes depending on sun exposure. – Anti-glare device: Due to it’s light absorbing properties the solar panel creates a surface with very low reflectivity across the bonnet of the vehicle.DescriptionThe VSS System hard-mounts to the bonnet of your vehicle, and during daylight hours, provides a constant flow of clean solar energy to your primary or secondary vehicle batteries. This gives you the ability to run 12V accessories like fridges, phone/laptop chargers, lights, power inverters etc. without the need to start your engine and without the fear of draining your battery and leaving you stranded. The VSS system is completely plug-and-play if paired with our optional MPPT solar charge controller and can be installed in as little as 1.5 hours. We chose the most stable and durable multilayers semi-flexible solar panel construction available to ensure that these solar panels can withstand extreme environmental conditions, maintenance-free, for years. The Future of Vehicle Charging is Here!FAQsWill Engine Heat Affect the VSS System? This is the most commonly asked question about our VSS System. It is a fact that solar cells lose efficiency as they warm up, however the simple answer is NO, engine heat will not have an effect on how the VSS system operates. Why you ask? Well, the main benefit of the VSS system is that it provides power to your vehicle battery when the engine is NOT running (and therefore not not). When the engine is running (and hot) the vehicle’s alternator is doing the majority of the charging and not the solar panel. This means there is very little effect from the additional heat on the system when the system is used for its intended benefits. In order to help with the heat build-up, each VSS panel is prepped with closed cell neoprene on the back of the panel. This serves two purposes; it lifts the panel up off of the bonnet creating an air packet between the panel and the bonnet allowing for cooling, while also helping to protect the vehicle bonnet from any contact with the back of the panel. Will the VSS System work with my battery? The MPPT charge controller included in our complete kits are programmed to charge a wide variety of battery types. Our system will work with AGM, Lead-Acid and Gel Cell Type Batteries. *we do not recommend the use of Optima Batteries with the VSS system. Can it be removed? Once installed the VSS system is not designated to be removed from the vehicle. The solar panel can be removed only if absolutely necessary. i.e., the panel needs to be replaced.Features Power 86W Maximum Power Voltage (Vmp) 24.36V Open Circuit Voltage (Voc) 28.74V Maximum Power Current (Imp) 3.49A Short Circuit Current (Isc) 3.83A

Reduce the drag and wind noise over the roof rack of your Toyota Rav4 with a wind fairing. The Slimsport Rack Wind Fairing channels air fluidly over your Slimsport Roof Rack (and the accessories loaded on it) to help reduce fuel consumption. It mounts quickly to the front of your roof rack and adds an overall bolder look.   A wind fairing for the Toyota Rav4 (2019-Current) Slimsport Roof Rack Kit. Air flows easily over the rack and accessories, reducing drag and wind noise. Helps fuel consumption while carrying bulky loads. A durable rubber blade is fitted to the bottom edge of the Wind Fairing to help seal any gaps and act as a roof guard when traveling over rough terrain. Brackets and installation hardware included. Consists of:1 x Toyota Rav4 Slimsport Rack Wind Fairing1 x Protection StripInstallation HardwareFitting Instructions Materials used:Black powder coated steel Product Dimensions:1175mm (46.3") L x 172mm (6.8") W x 203mm (8") H Weight:3.25kg (7.2lbs)

The Slimsport Rack Wind Fairing is specifically designed to pair with the 40” Front Runner Light Bar for a sleek look and even more functionality. After all, adventures don't end just because the sun goes down.   Light Bar Wind Fairing for the Toyota Rav4 (2019-Current) Slimsport Roof Rack Kit Allows installation of Front Runner 40" LED Slim Light Bar VX1000-CB SM / 12V/24V / Single Mount Designed to direct airflow over the rack and accessories, reducing drag and wind noise Helps reduce fuel consumption while carrying bulky loads Durable rubber blade is fitted to the bottom edge of the Wind Fairing to help seal any gaps and act as a roof guard when traveling over rough terrain Brackets and installation hardware included Consists of:1 x Toyota Rav4 Slimsport Rack 40" Light Bar Wind FairingInstallation HardwareFitting Instructions Materials used:Black powder coated steel Product Dimensions:1175mm (46.3") L x 178mm (7") W x 161mm (6.3") H Weight:4.94kg (10.9lbs)

Get easy access to the roof of your Toyota RAV4 with this four-step lightweight ladder. Now all you have to do is step up the ladder, and you can get to the cargo or sports gear on the rack or load bars on your RAV4. This is adventuring the easy way. A four step ladder for the rear hatch of the Toyota Rav4 5th Gen to access your cargo or sporting gear on your rack. Manufactured from aluminium and steel. Coated in the same resistant black powder coating as the Front Runner rack. Drilling is required for installation Fixes to the factory Hinge point and base of the rear door (drilling required at base). Supplied with installation hardware and fitting instructions. Maximum load rating of 110kg/242.5 lbs. Consists of:1 x LadderInstallation HardwareFitting Instructions Materials used:Black powder coated aluminiumBlack powder coated steel Product Dimensions:790mm (31.1") L x 195mm (7.7") W x 1003mm (39.5") H Weight:5.84kg (12.9lbs) Load Rating:110kg (242.5lbs)

Gear up your Toyota Rav4 (2019-Current) for any adventure with the Slimsport Roof Rack Kit. The Slimsport was designed for activity-focused drivers that do not require an expedition-grade build. It has a low-profile and is compatible with over 55 Front Runner accessories.   This low-profile flat deck Slimsport rack has a load-carrying area of 1676mm (66") x 1175mm (46.3"). The sleek side rails have integrated mounting feet. The mounting feet also have additional brace brackets for added strength. The high-strength aluminum slats have T-slots suitable for all Front Runner top mount accessories. Effortlessly access your Slimsport cargo with the Handle/Light Slimsport Rack Bracket Handle/Light Slimsport Rack Bracket. Easily add on the Slimsport Side Mount Accessory Bracket / Small for most Front Runner side mount accessories (sold separately). The included standard full fairing with rubber edge trim, makes the rack ultra-quiet. Need a lightbar? The optional lightbar fairing Toyota Rav4 (2019-Current) Slimsport Rack 40" Light Bar Wind Fairing (sold separately) has a 40" cutout to allow use of 40" LED Slim Light Bar VX1000-CB SM / 12V/24V / Single Mount (sold separately), and allows full operation of the moon roof. Fitment guide and all mounting hardware included. 6"/T30 Torx Allen Key for Slimsport Rack is required for installation. Note: Drilling required for installation. Note: Under Rack Tables and some side mount accessories such as Hi-Lift Jack Bracket and Recovery Device & Gear Holding Side Brackets are not compatible with the Slimsport rack kit range. All Front Runner Racks are backed by a Limited Lifetime Warranty* Note: Additional drilling is required for the RAV4 LE models.Note: The panoramic glass roof is not operational when this Rack Kit is installed. For panoramic glass roof the Toyota Rav4 (2019-Current) Slimline II Roof Rack Kit is suited, or Toyota Rav4 Adventure / TRD-Offroad (2019-Current) Slimline II Roof Rack Kit for adventure model.   KSTR003T - Toyota Rav4 (2019-Current) Slimsport Roof Rack Kit- by Front Runner Consisting of:1 x Toyota Rav4 (2019-Current) Slimsport Roof Rack Kit1 x RRAC238 - Toyota Rav4 (2019-Current) Slimsport Rack Wind Fairing1 x RRAC971 - Protection stripInstallation HardwareFitting Instructions Material Used:Black epoxy powder - coated T6 aluminiumHigh strength steel Assembled Rack Dimensions: 1676mm (66") L x 1175mm (46.3") W x 135mm (5.3") H Approximate Installed Weight: 34.74kg (76.59lbs) The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts. To determine the approximate height from your vehicle’s roof to the top of your Slimsport Rack add 60mm-70mm (2.4"-2.8") to the highest point of your roof. Shipping Dimensions:Width: 330mm (13")Length: 1705mm (67")Height: 220mm (9") Shipping Weight:Weight: 35kg (77lbs)